Chapter 8 5-Ghz Radio Module Upgrade; Upgrade Overview; Unpacking The Radio Module; Removing The 5-Ghz Radio Access Cover - Cisco 1232AG - Aironet - Wireless Access Point Hardware Installation Manual

Upgrade Overview

Upgrade Overview
This section provides instructions for upgrading the access point 5-GHz radio module. The following
operations summarize the upgrade procedure:
1.
2.
3.
4.
5.
Note After you install the radio module, all configurable radio settings will be at default values. Refer to the
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points for complete instructions on
configuring the new radio.

Unpacking the Radio Module

Each 5-GHz radio module is shipped with the following items:
•
•
•
•
If anything is missing or damaged, contact your Cisco representative for support.

Removing the 5-GHz Radio Access Cover

To remove the 5-GHz radio access cover, follow these steps:
Remove all cables and power connections from the access point.
Step 1
Place the access point on a flat surface so that the unit is upright with the front end facing you.
Step 2
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
8-2
Remove all cables and power connections from the access point.
Place your access point on a flat surface.
For an access point without the 5-GHz radio feature, remove the 5-GHz radio access cover.
For an access point with the 5-GHz radio feature, remove the existing 5-GHz radio module.
Install the new 5-GHz radio module.
Quick start guide
A product registration card
A T-10 tamper-resistant Torx L-wrench
A 5-GHz radio product compliance label
Chapter 8 5-GHz Radio Module Upgrade
OL-4310-01