Delay - FUTABA 10CAG Instruction Manual

DELAY : The Delay function provides a smooth transition between the trim positions whenever OFFSET , REVO. MIXING , or
THROTTLE HOLD functions are turned on and off.
GOAL of EXAMPLE:
Set up a delay on all channels to ease
to another so there are no "hard jumps."
Where next?
Adjustability:
• Separate delay times are available for aileron, elevator, rudder, throttle, and
pitch.
• With a 50% delay setting, the servo takes about a half-second to move to its
new position...quite a long time.
STEPS:
Open the DELAY function.
Adjust AILE response as needed. (Ex:
aileron to +8% .)
Repeat for other channels.
Close menus and confirm slowed
transitions.
THR-HOLD : see p. 99.
Setting up the Idle-Ups: Throttle and Collective pitch Curves and Revo. Mixing
( THR-CURVE, PIT-CURVE, REVO. MIX ) for idle-ups: see p. 101.
103
INPUTS:
for 1 second.
(If BASIC ,
C to DELAY .
to +8% .
C to ELEV . Repeat step above.
E (T10CHG) or G (T10CAG)
from NORMAL to IDL2 . Check that servos
move gradually to new positions.
again.)