FUTABA 10CAG Instruction Manual page 20

Operation Mode Select (R6008HS/R6014HS):
LED
The operation mode is on "Normal mode" from factory shipping. To change the mode, please adhere to the following
steps:
1. Turn off the receiver.
2. Press and hold the Link/Mode switch and turn on the receiver.
Keep holding the switch for more than one(1) second. The LED
3. Release the switch.
4. Turn off the receiver.
By doing so, the receiver will change modes.
Please check the operation mode by observing the LED when turning on the receiver. If possible ensure that there's no
FASST transmitter in operation near the receiver.
When the receiver is turned on:
•Red when on "Normal mode"
•Green and Red (makes Orange) when on "High Speed mode". (After two(2) seconds, change to Red.)
If there are some FASST transmitters turned on near the receiver, the LED may show the above status for a brief moment
before changing to the status indication as shown in the "LED indication" table above.
R6014HS
Link/Mode
Switch
Press and Hold time
Function
LED Status
20
Link/Mode
Switch
R6008HS
LED
Turn on the receiver.
0 sec. 1 sec.
0 to 1 sec. More than 1 sec.
To change the mode between
No function
Normal and High Speed
Showing the CURRENT Solid as the mode changed.
mode with blink.
Red Solid = Normal
Red Blink = Normal Green/Red Solid = High
Green/Red Blink = Speed
High Speed
(Become Red after one (1)
second)