FUTABA 10CAG Instruction Manual page 112

servos.
AUX-CH. ...................................................................................... 46
Channel delay: see THROTTLE DELAY ( ACRO ) and DELAY( HELI ).
Charge: to increase the electrical energy, measured as voltage, available in a battery pack. See Battery care and charging.
Condition: ( HELI
IDLEUP 1, 2,
3 and THROTTLE HOLD .
Contact information, North American Service Center. .......................................................................................................... 3
Copy model: see MODEL COPY .
Crow: see BUTTERFLY ( GLID ) and AIRBRAKE ( ACRO ).
Cursor: See SELECT BUTTONS.
Curve Mix: a mix that does not have the same reaction at all points along the master channel. See Programmable mix.
Cyclic: horizontal controls on a helicopter. Cyclic pitch is typically called elevator. Cyclic roll is typically called aileron.
RESET .
DELAY : ( HELI ) slows the servo's reaction time when changing from one condition to another. Eases any "jumps" in transition
from one pitch setting to another, etc. Also see THROTTLE DELAY , p. 59 ( ACRO ). ................................................................ 103
Delta peak charger: common name for a specialized charger designed and required to properly peak charge both NiMH
and NiCd batteries, actually called a Zero Delta V Peak Charger. See Battery Care and Charging.
Dial: transmitter's rotary control and button used in various ways during programming. .................................................. 11
Dial mix: mix that uses a knob or slider as the master control, moving the slave servo based upon the movement of the
knob or slider. See Prog. mix.
Differential: uneven movement in each direction of a control surface. Usually used when discussing ailerons or when
describing an undesirable unevenness in movement of other controls. See Twin aileron servos.
reversed polarity during charging. ....................................................................................................................................... 15
DIR-SW : switches that change between the four separate directions of snaps available. See SNAP ROLL .
Discharge: to deplete the electrical energy in a battery pack, usually to its lowest safe voltage, for storage or as a part of
regular maintenance. See Battery care and charging.
DP16K: see CAMPac.
Dual aileron servos: ( ACRO GLID ) a model using two servos on two separate channels to operate ailerons. May include
Twin aileron servos. ........................................................................................ 51
Dual elevator servos: ( ACRO GLID ) a model using two servos on two separate channels to operate elevators. Includes
elevon, V-tail, ailevator. See Twin elevator servos. ............................................................................................................. 56
Dual rates ( D/R , EXP
switches. Includes exponential function, see EXP. ................................................................................................................ 42
Elapsed Time Counter reset: see TIMER. ............................................................................................................................... 45
ELE1/2/3/4 : designation for the individual servos that are being commanded by the elevator command. Ex: when using
elevon, the two wing servos are acting as elevators 1 and 2. See Twin elevator servos.
Elevator: surface which controls the model's rate of climb or descent. Also called cyclic pitch on helicopters.
Elevator-to-airbrake mix: ( GLID ) used to allow the model to loop even tighter on elevator input by having airbrakes work with
elevators. Not a preprogrammed mix. See Programmable mix. This is the default programming for one curve mix in GLID .
112