FUTABA 10CAG Instruction Manual page 34

MODEL TYPE : sets the type of programming used for this model.
The T10CG has 15 model memories, which can each support:
•one powered aircraft ( ACRO
elevator servos, ELEVON , and V-TAIL for further information.);
•eight helicopter swashplate types, including CCPM. See Helicopter MODEL TYPE for details, p. 93.
(Each model memory may be set to a different model type.) If your transmitter is a T10CAG, the default is ACRO . If it is a
T10CHG, the default is HELI(H1) .
ACRO is the best choice for most powered airplanes, but in some circumstances, GLID(2A+1F) may be a better choice. ACRO
is usually a better choice because of functions it offers that the GLID types do not:
• ACRO adds:
• SNAP-ROLL
• AILEVATOR (twin elevator servo support)
•For fuel-powered airplanes: IDLE-DOWN , THR-CUT , THROTTLE-NEEDLE mixing and THROTTLE DELAY programming.
•But ACRO lacks:
•5 seperate conditions for optional setups ( START SPEED DISTANCE LANDING )
If you are using a glider or heli MODEL TYPE , please go to that chapter now to select the proper model type and support
your model setup. Note that changing MODEL TYPE resets all data for the model memory, including its name.
GOAL of EXAMPLE:
Select the proper MODEL TYPE for your
model. Ex: ACRO .
[NOTE: This is one of several functions
that requires confirmation to make a
change. Only critical changes require
additional keystrokes to accept the
change.]
STEPS:
Open the BASIC menu, then open the
PARAMETER submenu.
Go to MODEL TYPE .
Select proper MODEL TYPE .
Ex: ACRO .
Close PARAMETER .
34
MODEL TYPE for details, p. 78;
MODEL TYPE
INPUTS:
Turn on the transmitter.
for 1 second.
(If ADVANCE ,
then C to highlight PARAMETER .
to choose PARAMETER .
to TYPE .
C
to ACROBATIC .
Are you sure? displays.
to return to BASIC menu.
again.)
for 1 second.