Messages For Audio Functions - Pioneer AVIC Z3 - Navigation System With DVD player Operation Manual

Appendix
Appendix

Messages for Audio Functions

When problems occur in the audio source, a message may appears on the display. Refer to the
table below to identify the problem, then take the suggested corrective action. If the error persists,
contact your dealer or your nearest Pioneer Service Center.
Built-in DVD drive
Message
Unreadable disc
Playback error. Please remove
the disc.
Region code error
Playback error due to irregu-
lar temperature. Please re-
move the disc.
ATTENTION! Viewing of front
seat video source while driv-
ing is strictly prohibited.
Search error
Hard disk drive (Music Library)
Message
This CD cannot be recorded
• Recording error. Switching
to CD playback mode
• Recording error. Recording
is stopped
• The recording was unstable.
Restart the recording from
the beginning of the track.
184
En
When
If you try to use a disc which is in-
compatible with this system.
If you insert a disc upside down.
If the disc is dirty.
If the disc is cracked or otherwise
damaged.
Mechanical failure of DVD drive oc-
curs.
Electrical or mechanical error has
occurred.
The disc does not have the same re-
gion number as the navigation sys-
tem.
The temperature of the built-in DVD
drive exceeds the operating limits.
Parking brake interlock is activated. Park your vehicle in the safe place and apply
The title number, chapter number,
time, or 10 key command that you
enter in [10Key Search] do not
exist. (This message will appear
when the DVD drive cannot accept
that command.)
When
If you insert a CD which prohibits
second-generation copies or dupli-
cate.
If recording can not be carried out
due to continuous skipping on cer-
tain part of the disc because the
disc is dirty, scratched, or otherwise
damaged, the pick-up lens of the
DVD drive is dirty, or extreme vibra-
tion occurs continuously.
What to do (See)
Insert a suitable disc.
Insert the disc with the label upward.
Clean the disc.
Insert a normal, round disc.
Consult your Pioneer dealer.
Press RESET button. (Also see the Hardware
Manual.) (Page 187)
Replace the DVD-Video with one bearing the
correct region number.
Park your vehicle in safe place, turn the igni-
tion switch off, and wait until the built-in DVD
drive's temperature returns to within normal
operating limits.
the parking brake. (Page 22)
Enter the available numbers or 10 key com-
mand or use another search method.
What to do (See)
Use another CD and retry.
! Clean the disc and retry.
! Clean the pick-up lens with a commercially
available cleaning kit for DVD, then retry.
! Retry in vibration-free condition.