Messages For Audio Functions; Built-In Dvd Drive - Pioneer AVIC-Z2 Operation Manual

Message
Calibration failed.
Please refer to the owner's manual.
The HDD is not connected.
Cannot use HDD.
There is no applicable program.
The HDD cannot be operated due to
excessive heat.
Please move your vehicle to a safe
place and turn the power off until the
temperature goes down.

Messages for Audio Functions

When problems occur in the audio source, a message may appears on the display. Refer to the table
below to identify the problem, then take the suggested corrective action. If the error persists, contact
your dealer or your nearest PIONEER Service Center.

Built-in DVD drive

Message
Unreadable disc.
Playback error.
Please remove the disc.
Region code error
Playback error due to irregu-
lar temperature. Please
remove the disc.
ATTENTION!
Viewing of front seat video
source while driving is strictly
prohibited.
Search error
196
When
The touch panel calibration has not
been carried out with appropriate
steps.
Failure of the built-in hard disk drive
has occurred, such as internal elec-
trical problem or file system error.
Failure of the built-in hard disk drive
has occurred, such as internal elec-
trical problem or file system error.
Failure of the built-in hard disk drive
has occurred, such as internal elec-
trical problem or file system error.
Hard disk drive cannot run due to
high temperature.
When
If you try to use a disc which is incom-
patible with this system.
If you insert a disc upside down.
If the disc is dirty.
If the disc is cracked or otherwise dam-
aged.
Mechanical failure of DVD drive occurs.
Electrical or mechanical error has
occurred.
The disc does not have the same region
number as the navigation system.
The temperature of the built-in DVD
drive exceeds the operating limits.
Parking brake interlock is activated.
The title number, chapter number, time,
or 10 key command that you enter in
[10Key Search] do not exist. (This mes-
sage will appear when the DVD drive
cannot accept that command.)
What to do
Please read the instruction of touch
panel calibration and retry.
➞ Page 182
Consult your dealer.
Consult your dealer.
Consult your dealer.
Park your vehicle to safe place, turn
the ignition switch off, and wait until
the temperature inside the vehicle
drops.
What to do
Insert a suitable disc.
Insert the disc with the label upward.
Clean the disc.
Insert a normal, round disc.
Consult your Pioneer dealer.
Press the RESET button. ("Hardware
manual" after reading page 179 in this
manual.)
Replace the DVD-Video with one bearing
the correct region number.
Park your vehicle in safe place, turn the
ignition switch off, and wait until the
built-in DVD drive's temperature returns
to within normal operating limits.
Park your vehicle in the safe place and
apply the parking brake.
➲ "Parking brake interlock" ➞ Page 20
Enter the available numbers or 10 key
command or use another search
method.