Pioneer AVIC Z3 - Navigation System With DVD player Operation Manual page 176

Appendix
Appendix
No sounds are heard.
The volume level will not rise.
The volume of beeps and naviga-
tion guidance cannot be ad-
justed.
Adjusting the volume of naviga-
tion guidance and beeps is not
possible.
A strange sound is heard when
the vehicle comes close to a cer-
tain place (e.g. Dog barking).
An alarm sounds when you ap-
proach the registered location
and the set image pops up, re-
gardless of whether [Address
Book Icon] is set to [Off].
Slope is not displayed on Vehi-
cle Dynamics screen.
"Inclination" does not move on
3D Calibration Status screen.
No sound, no voice.
The person on the other end of
the phone call cannot hear the
conversation due to an echo.
The registered phone cannot be
deleted.
CD or DVD playback is not pos-
sible.
No picture.
176
En
The volume level is low.
The attenuator or mute is on.
The speaker lead is disconnected.
You cannot adjust these parameters
with VOL (a/b) button.
You cannot adjust them with VOL
(a/b) button.
The sound for the entry of [Address
Book] is set.
This is a normal operation and not a
malfunction.
The speed pulse lead is not con-
nected.
has been set, or sound volume
is reduced to 0.
The voice from the person on the
other end of the phone call is output
from the speakers and then picked
up by the microphone again, creat-
ing an echo.
Normally, the registered phone can-
not be deleted.
The disc is inserted upside down.
The disc is dirty.
The disc is cracked or otherwise da-
maged.
The files on the CD are an irregular
file format.
The CD format cannot be played
back.
The loaded disc is a type this system
cannot play.
The parking brake lead is not con-
nected or applied.
Parking brake interlock is activated. Park your vehicle in a safe place and apply
[AV Input] setting is incorrect.
Adjust the volume level.
Turn the attenuator or mute off.
Check the connection.
Turn the volume up or down with [Volume] in
[Settings] menu.
Turn the volume up or down according to [Vo-
lume] in [Settings] menu. (Page 88)
Set the sound setting of that entry to [No
Sound]. (Page 63)
To turn off the sound output and image pop
up, select [No Sound] and [No Picture].
Connect the speed pulse lead.
Adjust the volume of the guidance or turn
off. (Page 88)
Use the following methods to reduce the
echo:
—Lower the volume on the receiver
—Have both speakers pause slightly before
speaking
! Overwrite the old registered phone with a
new phone.
! Clear [Phone Settings]. (Page 187)
Insert the disc with the label upward.
Clean disc.
Insert a normal, round disc.
Check the file format.
Replace disc.
Check what type the disc is. (Also see "Hand-
ling and Care of the Disc" in the hardware
manual and "Page 199" for more cautions
about handling each type of media.)
Connect a parking brake lead correctly, and
apply the parking brake.
the parking brake. (Page 22)
Please read the following page and set the
setting correctly. (Page 150)