Entering Command Lines And Executing Programs - Texas Instruments TI-84 PLUS - Graphing Calculator Manual Book

3. Press } and † to move the selection cursor (4) next to the program you want to delete, and
then press {. The program is deleted from memory.
You will receive a message asking you to confirm this delete action. Select
Note:
continue.
To leave the
PRGM
home screen.
To increase available memory by archiving a program:
1. Press y L and then select
2. Select
2:Mem Mgmt/Del
3. Select to display the
7:Prgm...
4. Press Í to archive the program. An asterisk will appear to the left of the program to
indicate it is an archived program.
To unarchive a program in this screen, put the cursor next to the archived program and press
Í. The asterisk will disappear.
Archive programs cannot be edited or executed. In order to edit or execute an archived
Note:
program, you must first unarchive it.

Entering Command Lines and Executing Programs

Entering a Program Command Line
You can enter on a command line any instruction or expression that you could execute from the
home screen. In the program editor, each new command line begins with a colon. To enter more
than one instruction or expression on a single command line, separate each with a colon.
A command line can be longer than the screen is wide.
Note:
While in the program editor, you can display and select from menus. You can return to the program
editor from a menu in either of two ways.
• Select a menu item, which pastes the item to the current command line.
— or —
Press '.
•
When you complete a command line, press Í. The cursor moves to the next command line.
editor screen without deleting anything, press y 5, which displays the
2:Mem Mgmt/Del
to display the
MEM MGMT/DEL
menu.
PRGM
from the menu.
MEMORY
menu.
Chapter 16: Programming
to
2:yes
278