Data Harvest EASYSENSE VISION User Manual page 11

EASYSENSE VISION User guide
Opening and Saving files
Opening
If you are opening a file saved on a memory stick connect the USB memory stick to the USB host port
on VISION before selecting Open.

Select Open either from the Home screen or from the File menu.

Locate the EasySense data file (.SSL) and OK.
Saving
If you are saving to a memory stick connect the USB memory stick to the USB host port on VISION
before selecting Save As.

From the File menu select Save As.

A dialogue box will open to allow the captured data to be saved as an EasySense file. Select the
destination of your choice.

Type in a name for the file (saved by default as .SSL type).
Auto save
If the battery voltage level drops too low then VISION will auto-save data before shutting down. If this
happens connect VISION to mains power and hold down the power button until the starting up screen
appears. Select Open from the File menu – the data that had been collected will be saved in an .SSL
file called Auto-Saved Data in the User Files\Data Files folder.
Printing
VISION will print to most Hewlett Packard PCL compatible printers.
Connect a compatible printer to the USB host port
Print Graph or Print Table* is located in the File menu.
Note: VISION will only print greyscale with a HP Colour LaserJet printer (not in colour).
* Be aware that a table can use multiple pages to print.
System information
Powering EASYSENSE VISION
While VISION is connected to its mains power supply it will not use sleep mode and will remain
awake.
Generally there is no need to power down (reset) VISION except to speed up a battery recharge or to
restart VISION's EasySense software if a fault occurs. (Saved data will be safe, but any unsaved data
will be lost).

To power down VISION: press and hold down the green power button for about 4 seconds – a red
warning symbol will appear

To power VISION back on: press and hold down the green power button until the 'Application
loading' screen appears.
Mains power
Use VISION's mains power supply adapter to power and recharge its internal batteries. Connect the
power adapter to the power socket on the back of VISION and its power indicator will light.
Power supply specifications: 5V DC mains adaptor, able to supply 1000 mA, with a positive centre and
negative outer pin.
 Data Harvest Group Ltd.
, continue to hold until the screen goes blank.
11
on VISION (printer turned on).
D0233 (7)