Download Print this page

Midea MAP05S1AWT-A User Manual page 4

Advertisement

Do not install the unit in a location that may be exposed to combustible gas, as this
could cause re.
The unit has wheels to facilitate moving. Make sure not to use the wheels on thick
carpet or to roll over objects, as this could cause the unit to tip over.
Do not operate a unit that has been dropped or damaged.
Ensure the unit remains at least 3ft (1m) away from any combustible materials such as
bedding, curtains, and furniture
All wiring must be performed strictly in accordance with the wiring diagram located
inside of the unit.
The unit's circuit board(PCB) is designed with a fuse to provide overcurrent protection.
The speci cations of the fuse are printed on the circuit board, such as: T 3.15A/250V, etc.
When the water drainage function is not in use, keep the upper and lower drain plug
avoid a choking hazard.
Operation of Current Device
RESET
TEST
Grounding type wall receptacle
Do not, under any
circumstances, cut,
remove or bypass
the grounding prong.
Power supply cord with 3-prong grounding
plug and current detection device.
NOTE
• Do not use this device to turn the unit on or off.
• Always make sure the RESET button is pushed in for correct operation.
• If the power supply cord does not reset when the TEST button is pressed or
cannot be reset, it must be replaced. Please contact customer service for
assistance.
Plug in &
press RESET
The power supply cord contains a
current measuring device that detects
damage to the power cord. Test the
power supply cord as follows:
1.
Plug in the air conditioner.
2. The power supply cord will have TWO
buttons on the plug head. Press the
TEST button. A click will be heard as
the RESET button pops out.
3. Press the RESET Button. A click will
be heard as the button engages.
4. The power supply cord is now
supplying electricity to the unit. (On
some products this is also indicated
by a light on the plug head.)
NOTE
The power supply cord with this
air conditioner contains a current
detection device designed to reduce
the risk of re.
In the event that the power supply
cord is damaged, it can not be
repaired. It must be replaced with a
cord from the manufacturer.
4

Advertisement

loading
Need help?

Need help?

Do you have a question about the MAP05S1AWT-A and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Map07s1awt-a