Midea MAP05S1AWT-A User Manual page 24

FAN mode
Press the "MODE" button until the "FAN" indicator lights up.
Press the "FAN SPEED" button on the remote controller to choose the fan speed. The temperature can
not be adjusted.
Do not put the duct against window.
4. UP and DOWN buttons
Adjust (increasing/decreasing) temperature settings in 1°C/2°F (or 1°F) increments in a range of
16°C/60°F to 30°C/88°F (or 86°F).
NOTE:
The control is capable of displaying temperature in degrees Fahrenheit or
degrees Celsius. To convert from one to the other, press and hold the Up and Down
buttons at the same time for 3 seconds.
5. Display
It shows the set temperature in Cool or Auto mode while showing the room temperature in DRY or
FAN mode.
Shows Error codes:
EH00-EEPROM error.
EH60-Room temperature sensor error.
EH61-Evaporator temperature sensor error.
EC52-Condenser temperature sensor error (on some models).
EH0b-Display panel communication error.
EC-Refrigerant leakage detection malfunction(on some models).
Shows protection code:
P1-Bottom tray is full--Connect the drain hose to drain the water collected. If protection repeats, call
for service.
NOTE:
and unplug the power cord. Contact the manufacturer, its service agents or a similar
qualified person for service.
6. Other features
COMFORTSENSE feature (On some models)
This feature can be activated from the remote control ONLY and there is no indicator light on the control
panel.
The remote control serves as a remote thermostat allowing for the precise temperature control at its
location.
To activate the ComfortSense feature, point the remote control towards the unit and press the
ComfortSense button.
If the unit does not receive the ComfortSense signal during any 7 minutes interval, the unit will exit the
ComfortSense mode.
NOTICE: This feature is unavailable under FAN or DRY mode.
24