Midea MAP05S1AWT-A User Manual page 23

OPERATION INSTRUCTIONS
Electronic control operating instructions
1. POWER button
• Power switch on/o .
•
Activate wireless operation(on some models).
For the first time using the wireless function,
press the POWER button for 3 seconds to
initiate the wireless connection mode. The LED
display indicates 'AP' to signal that the wireless
connection can be set. If the connection to the
router is successful within 8 minutes, the
wireless indicator will illuminate. If connection
fails within 8 minutes, the unit exits wireless
connection mode automatically. After wireless
connection is successful, for some models press
MODE and UP(+) buttons at the same time for
3 seconds to turn o Wireless function and the
LED DISPLAY shows 'OF' for 3 seconds, press
MODE button and UP(+) to turn on Wireless
function and the LED DISPLAY shows 'On' for
3 seconds.
NOTE:
Upon restarting the wireless
function, it may take some time for the
device to automatically connect to the
network.
2. FAN button
Press to control the fan speed in AUTO, HIGH,
LOW, or CONT. The fan speed indicator
illuminates under di erent fan settings.
Continuous Fan function
In COOL or DRY mode, press the Fan button
fan function. When the function is turned on,
the Cont. fan light will illuminate, indicating the
fan will run continuously. When the function is
indicating that the fan will stop when the
compressor stops.
4. UP and DOWN
3. MODE
3. MODE button
Select the appropriate operating mode. Each
time the button is pressed, the modes are
selected in the order of AUTO, DRY, COOL
and FAN. The di erent mode indicators
illuminate at di erent mode settings.
NOTE:
In AUTO mode, the FAN
speed will be adjusted automatically.
AUTO mode
Press the "MODE" button until the "Auto"
indicator lights up. In this mode, the fan
speed or the temperature will be adjusted
automatically.
COOL mode
Press the "MODE" button until the "COOL"
indicator lights up.
Press the UP and DOWN buttons " " or " "
to select the desired room temperature.
DRY mode
Press the "MODE" button until the "Dry"
indicator lights up. In this mode, the fan speed
or the temperature cannot be adjusted. The
fan motor operates at Auto speed.
NOTE:
Keep windows and doors
closed for the best dehumidifying
e ect. Do not put the duct against
window.
23
5. Display
2. FAN
1. POWER