Launching Spyware Scanning In The Whole Domain - F-SECURE CLIENT SECURITY 7.00 Administrator's Manual

Step 3.
Step 4.
5.8.3

Launching Spyware Scanning in the Whole Domain

Changing Spyware Scanning to Quarantine
Automatically Configuration
Configure the Default Spyware Handling settings:
1. If you want to make sure that users cannot allow any spyware or
riskware to run on their computers, make sure that Permit users to
allow spyware is set to Not allowed.
2. Set spyware scanning to quarantine all detected spyware
automatically by clicking the
automatically quarantine all new spyware
confirmation dialog.
3. Check that the real-time spyware scanning settings are valid for the
managed domain. They are located in the Spyware Scanning on File
Access section.
4. Check that the manual spyware scanning settings are valid for the
managed domain.They are located in the Manual Spyware Scanning
section.
Distribute the Policy
Distribute a policy with the spyware handling settings to the whole
domain:
1. Click to save the policy data.
2. Click to distribute the policy.
In this example a manual spyware scan is launched in the whole domain.
This will partially clean out the Spyware and Riskware Reported by Hosts
table
1. Select Root in the Policy Domains tab.
2. Go to the Settings tab and select the Manual Scanning page.
3. In the Manual Spyware Scanning section, select Scan for spyware
during manual virus scan.
CHAPTER 5
Change spyware protection to
link. Click
187
Yes in the