84
B.1
Introduction
B.2
Before Installing Required Kernel Modules
B.3
Installation Instructions
This section describes how to install required kernel modules manually.
You may need to do this in the following cases:
›
You forgot to use Software Installation Mode and the system is
not working properly.
›
In large installations some hosts may not include development
tools or kernel source.
Before installing required kernel modules, you must do the following:
›
Make sure that the running kernel version is the same as the
version of the kernel sources installed. The kernel configuration
must also be the same.
›
On some distributions, such as older SUSE distributions, you
may need to go to /usr/src/linux and run commands
make cloneconfig and make modules_prepare before the
kernel sources match the installed kernel.
Follow the instructions below to install required kernel modules:
1.
Run the following command as the root user:
/opt/f-secure/fsav/bin/fsav-compile-drivers
2.
If the summary page in the user interface does not show any errors,
the product is working correctly.