Memory Groups; Memory Group Assignment; Choosing The Desired Memory Group - Yaesu FTDX-9000D Operation Manual

M G
1. Press the MNU key (#
2. Rotate the Main Tuning Dial knob (#
Menu item "GENERAL 031 MEM GROUP."
Rotate the CLAR/VFO-B knob (#
Menu item to "ENABLE" (the default setting is "DIS-
ABLE").
3. Press and hold in the MNU key for two seconds to
save the new setting and exit. Operation will now be
restricted to the six Memory Groups.
To cancel Memory Group operation, repeat steps (1)
through (3) above, choosing "DISABLE" in step (2).
Advice
Note that for the PMS memory group, the PMS memories
"P1L" through "P9U" will be so designated, so as to avoid
confusion.
You may recall memories just within a particular Memory Group, if desired.
1. Press the V/M key (#
Memory mode.
2. Press and hold in the MCH/GRP key (#
and to the left of the CLAR/VFO-B knob (#
for two seconds. The imbedded LED inside the switch
will light up.
3. Rotate the CLAR/VFO-B knob to select the desired
Memory Group.
To exit from Memory Group operation, press and hold in
the MCH/GRP key for two seconds once more.
Advice
H You will now be operating using memories only within
the selected Memory Group.
H If no channels have been assigned to a particular
Memory Group, you will not have access to that Group.
Page 114
M G
) to enter the Menu mode.
) to select
) to set this
C D
), if necessary, to enter the
) (below
A
Memory Channel Number
Groups Memory "OFF"
01 ~ 19
20 ~ 39
40 ~ 59
60 ~ 79
80 ~ 99
P-1L/1U ~ P-9L/9U
M G
))
FT 9000D O
MNU key
MCH/GRP switch
CLAR/VFO-B knob
Groups Memory "ON"
1-01 ~ 1-19
2-01 ~ 2-20
3-01 ~ 3-20
4-01 ~ 4-20
5-01 ~ 5-20
P-1L/1U ~ P-9L/9U
V/M key
MCH/GRP switch
CLAR/VFO-B knob
M