Quick Split Operation - Yaesu FTDX-9000D Operation Manual

Yaesu ftdx-9000d hf transceiver: operation manual
Hide thumbs Also See for FTDX-9000D:
Table of Contents

Advertisement

C
The Quick Split feature allows you to set a one-touch offset of +5 kHz to be applied to your radio's transmit frequency
on the Sub VFO, compared to the Main (VFO-A) frequency.
1. Start with regular transceiver operation on the Main
(VFO-A) band.
MAIN(VFO-A)
RX switch (#
TX switch (#
SUB(VFO-B)
RX switch (#
TX switch (#
2. Press and hold in the SPLIT switch (#
two seconds to engage the Quick Split feature, and
apply a frequency 5 kHz above the Main (VFO-A)
frequency to the Sub (VFO-B) frequency register.
Press and hold in the SPLIT switch for two sec-
onds to increment the Main (VFO-A) frequency to
+5 kHz.
The VFO configuration will then be:
MAIN(VFO-A)
RX switch "ON" (LED glows Green)
TX switch "OFF" (LED Off)
SUB(VFO-B)
RX switch "OFF" (LED Off)
TX switch "ON" (LED glows Red)
Quick Point
H The operating mode applied to the Sub (VFO-B)
register will be the same as that in use on the Main
(VFO-A) register.
H The offset of the Sub VFO from the Main VFO is
programmed via the Menu, and is set to +5 kHz at
the factory. Other offsets may be selected, however,
using the following procedure:
1. Press the MNU switch (#
mode.
2. Rotate the Main Tuning Dial knob (#
lect Menu item "GENERAL 032 QUICK SPLIT
FREQ."
3. Rotate the CLAR/VFO-B knob (#
the desired offset.
The available selections are
–10 kHz ~ 0 kHz ~ +20 kHz
(factory default: +5 kHz).
4. When you have completed all adjustments, press
and hold in the MNU switch for two seconds to
save the new setting and exit to normal operation.
If you only press the MNU key momentarily to
exit, any changes you performed will not be stored.
FT
9000D O
T
S
-F

Quick Split Operation

) "ON" (LED glows Green)
) "ON" (LED glows Red)
) "OFF" (LED Off)
) "OFF" (LED Off)
) for
) to enter the Menu
) to se-
) to select
M
A
O
MAIN(VFO-A)
TX switch "OFF"
MAIN(VFO-A)
RX switch "ON"
(LED glows Green)
SPLIT switch
MAIN Tuning Dial
SUB(VFO-B)
(LED Off)
RX switch "OFF"
(LED Off)
SUB(VFO-B)
TX switch "ON"
(LED glows Red)
MNU key
CLAR/VFO-B knob
Page 97

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ft dx 9000d

Table of Contents