Yaesu FTDX-9000D Operation Manual page 148

M M
154. TX MAX POWER
Function: Selects a maximum output power limit.
Available Values: 200/100/50/10 W
Default Setting: 200 W
155. TX PWR CONTROL
Function: Configures the RF PWR knob.
Available Values: ALL MODE/CARRIER
Default Setting: ALL MODE
ALL MODE: The RF PWR knob is enabled on all
modes.
CARRIER: The RF PWR knob is enabled in all
modes except SSB. In this configuration,
the SSB output power will be set to maxi-
mum, regardless of the RF PWR knob's
position.
156. EXT AMP TX-GND
Function: Enables/Disables the TX GND jack on the
rear panel.
Available Values: ENABLE/DISABLE
Default Setting: DISABLE
157. EXT AMP TUNING PWR
Function: Selects a maximum output power limit for
driving the input circuit of an external linear RF am-
plifier while tuning (while using the Remote Control
function of the linear RF amplifier).
Available Values: 200/100/50/10 W
Default Setting: 100 W
Page 146
TX GNRL G
158. FULL DUPLEX
Function: Enables/Disables Full Duplex operation.
Available Values: SIMP/DUP
Default Setting: SIMP
When this menu is set to "DUP," you may receive on
the sub band (VFO-B) frequency while transmitting,
during dual receive operation, on a different band on
the main band (VFO-A).
159. VOX SELECT
Function: Selects the audio input source for trigger-
ing TX during VOX operation.
Available Values: MIC/DATA
Default Setting: MIC
MIC:
DATA: The VOX function will be activated by data
160. EMERGENCY FREQ TX
Function: Enables Tx/Rx operation on the Alaska
Emergency Channel, 5167.5 kHz.
Available Values: DISABLE/ENABLE
Default Setting: DISABLE
When this Menu Item is set to "ENABLE," the spot
frequency of 5167.5 kHz will be enabled. The Alaska
Emergency Channel will be found between the
Memory channels "P-1" and "01 (or 1-01)."
The VOX function will be activated by micro-
phone audio input.
audio input.
FT 9000D O M