I
C
M
This transceiver was shipped from the factory in configuration for a microphone input via the Front Panel XLR
connector. To use the Rear Panel microphone with an 8-pin round connector, please change the microphone set up
via the Menu.
1. To do this, first press the MNU key located an the bottom right corner of the TFT display.
2. The Menu list will appear on the TFT display screen.
3. Rotate the Main tuning dial (VFO-A) to select menu item #069 (MODE-SSB 069 SSB MIC SELECT).
4. Now rotate the CLAR/VFO-B knob to change the setting to Rear.
Available selections are FRONT-REAR-DATA-PC.
5. To save the set-up, press and hold in the MNU key for 2 seconds.
If the MNU key is not held for 2 seconds, the set-up will not be saved.
Note : To use the AM or FM mode, please select Menu items 040 for AM and 059 for FM, and follow the same
procedure above.
1/4-inch 3-contact jack
Stereo Headphones
FH-2 Remote Control
Keypad
FT
9000D O
, H
② MIC-Hot
LOCK
ON
OFF
M
I
FH-2 R
① MIC-GND
③ MIC-Cold
XLR connector Type Microphone
⑧
MIC
⑦ MIC GND
① UP
② +5V
⑥ PTT
③ DOWN
⑤ GND
④ FAST
8-pin Connector Type Microphone
C
K
Page 15