3xLogic VISIX VX-5M622-MB-RIAW-X Quick Start Manual page 4

QUICK START GUIDE | VX-5M622-MB-RIAW-X
POWER
1. Disconnect the power plug from the outlet before connecting to the power terminal block. Connect the
device to the power line after fixing it firmly to the power connection terminal. Connect the power plug to
the outlet to power the device.
2. Do not extend the adapter output cable. If you need to install the power cable extension, please contact the
service center.
3. If there is smoke or a strange smell from the power source, disconnect the power immediately and contact
the service center or purchasing office. If you continue to use it as it is, it can cause fire and / or electric
shock.
INSTALLATION
1. Avoid installing cameras facing bright light like sunlight.
2. Make sure the camera is safely secured when mounting on the wall or ceiling. Falling hardware can cause
injury.
3. Do not connect multiple cameras to one adapter. Excess capacity can cause excess heat and fire.
4. Wear protective gloves when installing / uninstalling the camera. This prevents burns caused by high tem-
perature on the surface of the product.
5. Do not drop or shock the product. Please stay away from places where vibration is severe or strong magnet
are present.
6. Install the device according to the temperature and humidity environment suitable for the product spe-
cifications. Otherwise, it can cause fire and electric shock.
7. Thunder and lightning can cause problems with the camera. When installing, be careful to minimize damage
caused by lightning by grounding of the device.
8. Do not install it in places where there is excess moisture, dust, soot, etc. This could cause fire and / or elec-
tric shock.
9. Avoid installing in direct sunlight or in areas emitting excess heat, such as heating appliances.This could
cause fire and / or electric shock.
CLEANING
1. If the camera lens is dirty, wipe the contaminated surface with a clean, soft, dry cloth. If dirt remians, wet
the soft, dry cloth (but ring out the cloth to prevent water from flowing) then wipe and dry the contaminated
area.
2. Do not spray water directly on any part of the product when cleaning. This could cause fire and/or electric
shock.
/
4 6