Circontrol Post eVolve Series Installation Manual page 8

Post eVolve Series - Installation Manual
2
I M P O R T A N T S A F E T Y I N S T R U C T I O N S
The Charge Point is designed to be installed both in indoor and outdoor areas. For
each of the different conditions of installation, the unit must be installed safely and
ensure adequate protection.
• Charge Point shall not be installed in
areas where there is potential risk of
explosions.
• Do not install the Charge Point where
falling objects
equipment.
• The Charge Point can be installed in
locations with non-restricted access.
• The surface where the Charge Point
is placed must withstand mechanical
forces.
• Do not use this unit for anything other
than electric vehicle charging modes
considered in IEC 61851-1:2017.
• Do not modify this unit. If modified,
CIRCONTROL will reject all responsibility
and the warranty will be void.
Refer to TECHNICAL DATA section for more information about environmental
installation conditions.
04
Read carefully all the instructions before starting in
order to ensure properly installation of the Charge Point.
may damage the
• Comply strictly with electrical safety
regulations according to your country.
• Do not make any repairs or manipulations
with the unit energised.
• Only trained and qualified personnel
should have access to low-voltage
electrical parts inside the unit.
• Check the installation annually by a
qualified technician.
• Remove from service any faulty item
potentially dangerous for users (broken
plugs, caps that don't close...).
• Use only Circontrol supplied spare parts.
• Do not use this product if the enclosure
or the EV connector is broken, cracked,
open, or shows any other sign of
damage.