Table of Contents
Advertisement
8.
Maintenance
8.1.
Safety Instructions for Maintenance
DANGER
Electric shock caused by dangerous voltage inside
Disconnect power supply before servicing or cleaning.
8.2.
Preventive Maintenance
Attention
Before each use, examine the device visually for any defects.
Make sure that:
•
•
All screws used for installing the device or parts of the device are tightly fastened and are not corroded.
•
•
The safety devices are not damaged.
•
•
There are no deformations on housings, fixings and installation points.
•
•
The lens is not cracked or damaged.
•
•
The power cables are not damaged and do not show any material fatigue.
8.2.1. Basic Cleaning Instructions
The external lens of the device must be cleaned periodically in order to optimize the light output. The cleaning
schedule depends on the conditions at the site where the device is installed. When smoke or fog machines are
used at the site, the device will need more frequent cleaning. On the other hand, if the device is installed in
well-ventilated area, it will need less frequent cleaning. To establish a cleaning schedule, examine the device
at regular intervals during the first 100 hours of operation.
To clean the device, follow the steps below:
01) Disconnect the device from the electrical power supply.
01)
02) Allow the device to cool down for at least 15 minutes.
02)
03) Remove the dust collected on the external surface with dry compressed air and a soft brush.
03)
04) Clean the lens with a damp cloth. Use a mild detergent solution.
04)
05)
05) Dry the lens carefully with a lint-free cloth.
06) Clean the DMX and other connections with a damp cloth.
06)
Attention
•
•
Do not immerse the device in liquid.
•
•
Do not use alcohol or solvents.
•
•
Make sure that the connections are fully dry before connecting the device to the power supply and to
other devices.
c
32
ACT Flood 200 RGBAL
Product code: 34042
Advertisement
Table of Contents
Need help?
Do you have a question about the 34042 and is the answer not in the manual?