Using The Menus 2; Setup Using The Setting Display (2); Setting Up The Network Projector/Network Utility - Toshiba TLP-X200U Owner's Manual

Using the menus 2

Setup using the Setting display (2)

■
 Projector settings (Be sure to read this subsection.)
Using the factory settings as-is may suffer security damage, so be sure to change
the projector settings.
1. Press the NETWORK button and press the MENU button twice
2. Select a Category
Select a category by using
.
The following 5 categories are
available:
Network Projector
p.51
setup
Network utility
p.51
setup
Control setting p.57
Slideshow setup p.58
Status display p.60
3. Make settings
Press or
Item
The figure shows a typical example. As the display may differ depending on the
item, use the following pages as a reference.
While the video file transfer function of Network Utility or the slideshow function is
in use, the background image of the Setting display (2) does not appear.
4. Back RETURN button
5. End Press the MENU button or RETURN button.
(The menu disappears 30 seconds after the last operation is conducted.)
The Setting display (2) is displayed.
* Appears only when Network or USB memory input is selected.
Displays the current settings
of selected category.
Item shown in gray cannot
be set with the currently set
conditions of the projector.
to open the menu.
These marks signify the items can be
selected from the list by using .
After an item is selected, apply it by
pressing .
50

Setting up the Network Projector/Network Utility

■
If you select Network Utility, the following items can be set.
Category
Item
Easy Connect
Wireless
[Yes No]
LAN (USB memory)
LAN settings
Mode: Ad hoc
SSID: Specify a desired character string (1 to 32 characters).
[
DHCP: Use
IP address: Enter using the numeric keys of the remote control.
[
Subnet mask: Enter using the numeric keys of the remote control.
[
Gateway: Enter using the numeric keys of the remote control.
[
Confirm: [OK]
Security
Network authentication: Network Authentication Setting
[ or
None/Open/Shared/WPA-PSK/WPA2-PSK
Encryption: Select an encryption type using the
Off/WEP/TKIP/AES
Key index: Select a desired number (1 to 4) using the
Network key: Specify a desired character string.
(WEP: 5 to 13 characters, or 10 to 26 digits in hexadecimal notation)
(TKIP/AES: 8 to 63 characters, or 64 digits in hexadecimal notation)
[
Confirm: [OK]
Setting
Reset all the wireless LAN settings.
Iinitialization
Confirm: [Yes]
LAN settings
Wired DHCP: Use
LAN
IP address: Enter using the numeric keys of the remote control.
[
Subnet mask: Enter using the numeric keys of the remote control.
[
Gateway: Enter using the numeric keys of the remote control.
[
Confirm: [OK]
* To enter characters, use the numeric keypad on the remote control.
Description
[Enter: ]
Infrastructure
: Move left or right one character.] [ to : Set a character.]
Not use
: Move left or right one character.] [ to : Set a character.]
: Move left or right one character.] [ to : Set a character.]
: Move left or right one character.] [ to : Set a character.]
[Cancel] [Enter: ]
: Enter setting] [ : Selection] [Enter:
button.
buttons.
: Move left or right one character.] [ to : Set a character.]
[Cancel] [Enter: ]
[No] [Enter: ]
Not use
: Move left or right one character.] [ to : Set a character.]
: Move left or right one character.] [ to : Set a character.]
: Move left or right one character.] [ to : Set a character.]
[Cancel] [Enter: ]
51
]