Icom IC-7760 Addendum page 13

Partial reset
Changed
The Antenna memory contents are not cleared, even if
you perform a Partial reset.
Items that are not cleared after performing a
Partial reset:
• Pairing information of the controller and RF deck
• Memory channel/Keyer memory/RTTY memory/
PSK memory/Preset memory/Antenna memory
contents
• Internal antenna tuner preset points
• DPD adjustment value
(only for user adjustment values)
• Network settings
• REF Adjust
• MY Call
• User Band Edges
• Fixed Edges
All reset
Changed
The pairing information and RF deck's static IP
address settings are not cleared, even if you perform
an All reset on the controller.
NOTE: If the controller and RF deck connection fails
even when directly connecting then with the supplied
control cable, perform an All reset with directly
connecting them.
All reset for the RF deck
Added
An All reset for the RF deck resets the items listed
below, that are saved onto the RF deck.
• REF Adjust
• DPD adjustment value
(only for user adjustment values)
• Internal antenna tuner preset points
• Pairing information
• RF deck's static IP address settings (IP address,
Subnet mask, and Default gateway)
To perform an All reset for the RF deck, do the
following steps.
RF deck
(front panel)
[I/O]
2
1
While holding down [RESET],
turn ON the RF deck.
Keep holding down [RESET]
for more than 10 seconds
after turning ON the RF deck.
After the [POWER] indicator
starts blinking violet, release
[RESET], and then push it
again.
3
[RESET]
NOTE: If you release [RESET] before the [POWER]
indicator starts blinking violet, the All reset is canceled
and the RF deck is turned ON in normal mode.
In that case, perform an All reset again.
13
V1.10
RF deck
(rear panel)
[POWER] indicator
Orange
Violet
10 seconds later
Blinks violet
(All Reset mode)
Orange
All reset has been
finished.