Compaq 3000R - ProLiant - 128 MB RAM Notice page 8

9. Open Drive A: folder.
10. Open the w2kvp folder.
11. Double click w2kvp.reg. (You may not see the file extension depending upon how
you have your system configured.)
The content of the w2kvp.reg file is as follows:
REGEDIT4
[HKEY_LOCAL_MACHINE\SYSTEM\ControlSet001\Control\Graphics
Drivers\DisableUSWC]
12. Click Yes at the popup dialog box to confirm the registry changes.
13. Click OK to finish the registry update.
14. Remove the diskette and perform a Shutdown, Restart.
15. Let the system boot as usual and login.
16. Test the system by changing the video resolution to 800x600 and running "Disk
Administrator" to prepare the system.
Special Instructions for Installing Windows 2000 on an HP NetServer
LP 1000r or LP 2000r
NOTE: There are no embedded 53C1010 Ultra 3 SCSI boot device drivers
included on the Windows 2000 CD-ROM
Before you begin the installation of Windows 2000 on an LP 1000r or LP 2000r, create
the "Windows 2000 Drivers Diskette for the embedded 53C1010 Ultra 3 SCSI." (Created
from HP Navigator CD-ROM) See the instructions for creating drivers diskettes earlier
in this document.
After the installation of Windows 2000, the Windows 2000 Device Manager will detect
SDR GEM318 SCSI Processor Device as Other Device because Windows 2000 does not
have the SAF-TE.INF file.
To solve this issue, perform the following steps:
1. Create the "HP SAF-TE.INF file Diskette." (Created from HP Navigator CD-ROM).
See the instructions for creating drivers diskettes earlier in this document.
2. Install Windows 2000 using the procedure given below.
3. After the installation, go to the Device Manager, click on Other Devices.