Compaq 3000R - ProLiant - 128 MB RAM Notice page 27

st
The 1 reboot occurs within the first few minutes after installation has started.
You will see the following message on the screen:
Restarting the computer
This portion of Windows 2000 has completed
successfully
Your computer will restart in 15 seconds
nd
The 2 reboot occurs about 10 minutes after the installation starts. You will
see the following message on the screen:
This portion of
If there is a floppy disk, remove it.
Your computer will reboot in 14 seconds.
In both cases, remove the Windows 2000 CD from the CD ROM drive before
the system reboots.
Tip #6. Avoid using IRQ 9 on NetServer LH 4
Issue: If you configure any adapter to use IRQ9 on a NetServer LH 4, Windows 2000
will not configure the adapter. The device manager will report an error code 12, meaning
no resources available. Also, if the boot drive is on a SCSI adapter with IRQ9 the system
will fail to boot with a STOP 7B(0xF401b848, 0xC0000034, 0x0, 0x0).
Workaround: HP recommends that you use one of the following workarounds for this
problem.
1. Do not use IRQ9. Hewlett-Packard is working on a final fix for this issue.
2. If you must use IRQ9 with an LH 4, change the BIOS "Routing Algorithm" setting
from SMART to FIXED IRQ routing. The LH 4 BIOS SMART IRQ routing logic
does not allow IRQ9 to be shared. The ACPI logic uses IRQ9.
The following steps explain how to make this change.
1. Reboot system and press F2 during initial self-test.
2. Press right arrow to select "PCI Slot Devices".
3. Press Enter.
4. Press down arrow to select "PCI IRQ Locking".
setup is completed successfully.