Compaq 3000R - ProLiant - 128 MB RAM Notice page 10

c) When prompted to insert driver diskette, please insert the target adapter
driver's diskette created with the HP Navigator CD-ROM. Press Enter to
continue.
d) Select the target device driver from the list provided on the display. For
example, if you have the "HP NetRAID-4M", select "Hewlett Packard NetRAID-
4M RAID CONTROLLER".
if you have the "HP NetRAID-1M/2M", select "Hewlett Packard NetRAID-
1M/2M RAID CONTROLLER".
Please repeat the above step for the "HP NetRAID-2M and 1M"
e) If you have no other drivers that you need to install, press Enter to continue
with the installation.
3. Press Enter to continue at the "Windows 2000 Server Setup. Setup Notification..."
screen.
4. Press Enter to continue at the "Windows 2000 Server Setup. Welcome to Setup..."
screen.
5. Press C to continue Setup at the "Setup has determined that your computer's startup
hard disk is new..." prompt.
6. Press F8 to accept the licensing agreement.
7. At the drives partitioning screen, select the target drive. If you want to use the entire
drive to install Windows 2000 then press Enter. Otherwise, press C to create a drive
a partition.
(In this example we will create a 2GB partition. Please note that Windows 2000 does
not have the 2GB partition size limitation present on NT 4.0.)
8. Type 2048 and press Enter at the Create partition size prompt.
9. HP recommends that you create all the partitions needed for each hard drive present
on your system at this time.
10. Select the target drive to be used to install Windows 2000. Press Enter.
11. Select Format the partition using the NTFS file system and press Enter.
12. The installer will format and copy files to the hard drive. The system will then reboot.
13. Click Next to continue at the Setup Wizard first dialog box.
14. The Installing Devices screen will be shown with a progress bar on the display. This
may take 10 to 15 minutes.