Hardware Status Check - Compaq 3000R - ProLiant - 128 MB RAM Notice

Hardware Status Check

In this section you will run the "Device Manager" tool to identify any issues with the
installed devices or resource conflicts.
1. Right click My Computer.
2. Click Properties. This brings up the "System Properties" panel.
3. Click Hardware tab.
4. Click Device Manager... button.
5. Verify that no devices have either a yellow band (!) or question mark (?) symbol next
to it. (See following note for pointer to exceptions)
Yellow (!) means that there is a resource issue with the device.
Question (?) means that the device is unknown.
NOTE: Hewlett Packard and Microsoft have identified some devices that
under normal conditions can produce (!) or (?) marks. Please see table 5 in
the Appendix A of this document for an interpretation.
6. If no (!) or (?) symbols are reported then you are done. Go to step 9. Otherwise, do
the next step.
7. Double click on each of the devices with (!) or (?). Note the "Device Status"
message. Or if a printer is available, use the View, Print from the menu to get a
report.
8. See table 5-7 to verify any errors detected in steps 6 and 7.
9. Verify if the installed drivers are digitally signed.
A. In the Device Manager, click on the device (e.g HP NETRAID 1M/2M) that
want to verify.
B. Right click on that device.
C. Click Properties option.
D. Click on Driver Tab
E. Locate the" Digital Signer:" If the driver of that device is digitally signed then
it will display "MS Windows 2000 Publisher" or " Microsoft Windows
Hardware Compatibility Publisher".
If the driver of the device is not digitally signed we recommend that you