Compaq 3000R - ProLiant - 128 MB RAM Notice page 28

5. Press Enter.
6. Routing Algorithm should be selected. Verify that it is set to SMART.
7. Press Enter.
8. Select "Fixed".
9. Press F10 to save and Exit.
10. Press Enter to select "Yes".
11. The system will reboot.
Tip #7. Using the Windows 2000 integrated backup utility with
NetServer E60 and E 50 bundled tape drives
The backup utility in w2k has a "Backup Destination" pull down menu with the following
choices:
File
minQIC
Travan
The T20 tape drive shipped with the NetServer E 60 requires that you set this option to
minQIC when using 20GB cartridge. If you plan to use an 8GB cartridge (read-only
mode supported) then change this setting to Travan.
The T4 tape drive shipped with the NetServer E 50 requires that you set this option to
Travan. The T4 tape drive only supports 8GB cartridges.
It you don't set this option properly the backup utility will report that either the tape drive
is broken or the media is full.
Tip #8. Configure the Parallel (LPT) Port for ECP Mode
HP recommends that you configure the LPT port for ECP mode. Otherwise the device
manager may not show this port on the list. This configuration change is made by using
the following procedure:
1) Press F2 during power on self-test.
2) Select "I/O Device Configuration".
3) Select "Parallel Port".
4) Select "Mode". (Notice the current setting. It may read "Output Only".)