Compaq 3000R - ProLiant - 128 MB RAM Notice page 11

NOTE: If you see a dialog box titled "Digital Signature Not Found".
Please click "Yes" to continue the installation and read Tip #14 in the
troubleshooting section of this guide.
15. Click Next at the regional Settings screen.
16. At the Personalize Your Software screen, enter a name and organization. Then
click Next.
17. Enter the product license key.
18. Click the Per Seat radio button. (At the Licensing modes screen)
19. Click Next
20. At the Computer Name and Administrator Password type in your computer name,
administrator password and password confirmation. Then click Next.
21. Click Next at the Windows 2000 Component screen to accept default values.
22. Enter the proper date and time and click Next .
23. The Networking Setting screen starts with a progress bar chart.
24. Click Next to accept the default Typical settings.
25. Click Next at the Workgroup or Computer Domain to accept the default:
"No, This computer is not on a network, or is on a network without a domain..."
and
"Workgroup or computer domain: WORKGROUP."
NOTE: For Windows 2000 DataCenter, you must enter either the domain or
workgroup name before you can proceed to the next step.
26. The Installing Components screen starts with a progress bar chart. It takes about 20
minutes to complete this section. The wizard will then start the "Performing Final
Tasks" section to complete the installation.
27. Click Finish to complete the installation. Remove the CD from the drive. The system
will then reboot from the hard drive.
NOTE: There may be a period of time with no apparent activity after it displays a
message that reads "OS Loader Version 5.0". Be patient.
28. Follow screen instructions to logon. Enter user-id and password.
29. Read Tip #18 to install the Windows 2000 Recovery Console to enhance the system's
configuration.