Compaq 3000R - ProLiant - 128 MB RAM Notice page 25

device on the PCI bus. Furthermore, there must be an additional storage controller
configured to boot in sequence after the Adaptec SCSI controller.
· The LH Pro, LD Pro & LH II system will hang during Windows 2000 installation if
you attempt to boot from the Windows 2000 CD and any Adaptec SCSI controller
(including the system's embedded SCSI controller) is configured as the 1
device on the PCI bus, and it is connected only to a CD ROM drive. Furthermore,
there must be an additional storage controller configured to boot in sequence after the
Adaptec SCSI controller.
NOTE: The boot order is: slot 1, slot 2, slot 3, slot 4, embedded SCSI A,
embedded SCSI B, slot 5 and slot 6.
Workaround:
1. To install Windows 2000 to a hard disk device attached to the embedded SCSI:
· Fresh Windows 2000 installation:
Install Windows 2000 using Windows 2000 Setup diskettes.
The system will reboot once during installation.
Make sure the Windows 2000 CD is NOT in the CD ROM drive during
system reboot.
Follow the steps outlined in the section "Starting the Installation Windows
2000 Using Setup Diskettes".
At step #12, after set up has initialized the Windows 2000 configuration,
(about 20 minutes after installation starts), you will see the following
message on the screen:
This portion of
If there is a floppy disk, remove it.
Your computer will reboot in 14 seconds.
Remove the Windows 2000 CD from the CD ROM drive before the system
reboots.
· Upgrade from NT 4.0 to Windows 2000:
Boot to NT 4.0, then upgrade to Windows 2000.
The system will reboot twice during installation.
setup is completed successfully.
st
bootable