Verifying Creation Of The Cluster - Compaq 124708-001 - ProLiant Cluster - 1850 Software User's Manual

1-8 Compaq ProLiant CL1850 Software User Guide

Verifying Creation of the Cluster

IMPORTANT: Server node 2 cannot have the same SCSI ID as server node 1. For
example, if server node 1 is set for SCSI ID 7 then server node 2 must be set to ID 6.
5. To verify or change the SCSI ID number after the system configuration
is done, select Review or Modify Hardware Settings then press Enter.
This allows you to see all of the hardware settings.
6. Select Step 3: View or Edit Details.
7. Arrow down to Compaq 64-Bit Dual Channel Wide Ultra2 SCSI
Controller (Port1). Underneath this heading is a subheading titled SCSI
ID. To change the setting, highlight the SCSI ID option then press
Enter. After making a new selection, press Enter to accept the change.
8. Press F10 to exit.
9. Select Step 5: Save and Exit then press Enter.
10. Select Save the Configuration and Restart the Computer, then press
Enter.
11. From now on SmartStart is no longer involved in the installation
process. Follow the instructions offered by Windows NT.
12. After Windows NT, Service Pack 3, and MSCS are installed, install the
latest Service Pack if applicable.
13. To ensure latest Compaq drivers have not been overwritten by the
service pack, rerun the Server Support Software.
Now that the software is installed, use the following steps to verify the
creation of the cluster.
1. Shut down and power down both server nodes.
2. Power down and then power up the shared storage area.
3. Power up both server nodes.
When Windows NT finishes booting up on both server nodes, follow these
steps to use Microsoft Cluster Administrator to verify creation of the cluster:
1. From the desktop on either server node, select Start, Programs,
Administrative Tools (Common), Cluster Administrator.
2. When prompted for the cluster or server name, enter the name or IP
address of one of the server nodes.