Compaq 124708-001 - ProLiant Cluster - 1850 Software User's Manual page 13

System Setup and Configuration for Microsoft Windows NT S/E 4.0 1-3
8. Select Step 5: Save and Exit then press Enter.
9. The Product Selection window appears. Continue to follow the guided
installation process, selecting options as needed. If you need help, refer
to the online help by clicking on the Help button.
10. At the end of the Windows NT installation, you have the option of
viewing the Error Log. You may view the log by clicking on Yes. When
you select No, the system reboots.
11. Log on to Windows NT.
12. If you elected to install Compaq Insight Agents, a configuration screen
appears. Configure the agents as needed.
13. A prompt to load Service Pack 3 appears. Insert the Microsoft
Windows NT Server 4.0, Enterprise Edition CD #1 and click OK. When
the Confirm File Replace window appears, select No To All.
14. After Service Pack 3 is loaded, remove the CD and click OK. The
system reboots.
15. Log on to Windows NT. Exit the installation of Enterprise Edition
Installer.
16. Start the CR3500 Configuration Utility found in the Compaq System
Tools Folder. This utility allows you to configure the shared storage
RAID controllers and set up the logical drives. See Chapter 3, "CR3500
Configuration Utility," for detailed information on this utility.
NOTE: When using the CR3500 Configuration Utility, it is only necessary to configure the
shared drives during server node 1 setup. When configuring server node 2, the utility
shows the results of the shared drives configured during the server node 1 setup.
NOTE: Compaq recommends that you create a 100-MB quorum drive to store cluster
information.
17. After the shared storage drives have been configured, run the
Windows NT Disk Administrator to create volumes out of the logical
drives. Be sure to assign drive letters and format the volumes for NTFS.
18. Close Disk Administrator and restart Windows NT.
19. At the Enterprise Edition Installer, install Microsoft Cluster Server
(MCCS) Administrator. Refer to MSCS documentation for installation
steps.
20. After installing MSCS, install the latest Service Pack, if applicable.