Table of Contents
Advertisement
Altos G330 Installation Configuration Guide
Software Required
The management utility of onboard SATA RAID can be found in the G330
Resource CD build 100 (or later).
Software
Onboard SATA
RAID Monitor
Utility
Configuring Onboard LSI SATA RAID
Please refer to the Appendix B. for the onboard LSI SATA RAID configuration.
Installation Tips
Since Red Hat Enterprise Linux 4.0 Update 3 cannot recognize the
1.
onboard LSI SATA RAID, you need to make a driver diskette from the
Resource CD first before the installation.
Type linux dd when the prompt boot: appears at the start.
2.
Follow the instruction to load onboard LSI SATA RAID driver from the
3.
driver diskette from floppy (fd0).
At Package Defaults page, select Customize the set of packages to be
4.
installed. And select Development Tools under Development in the
Package Group Selection.
Follow the normal procedure to finish the installation.
5.
Gigabit Ethernet Driver Installation
The Red Hat Enterprise Linux 4.0 Update 3 can detect the onboard Intel 82573E.
But we recommend replacing the driver with the one in G330 Resource CD.
1.
Stop the network interface
# service network stop
2.
Remove the module e1000
# rmmod e1000
3.
Make the driver diskette for G330 Resource CD.
4.
Copy driver from floppy to hard disk
# mount /media/floppy
# cp –R /media/floppy/. /tmp/
5.
Change the directory to the driver source and install the driver
# cd /tmp/src/
# make install
# insmod e1000.ko
32
Version
Directory on Resource CD
1.11.0
\APP\G330\SATARAID\Monitor\linux\
Advertisement
Table of Contents
