5 Press
button until Wireless Setup is highlighted, and then press the
(Set) button.
6 Press
button until WPS is highlighted, and then press the
7 Press
button until PIN Code is highlighted, and then press the
button.
8 Write down the 8-digit PIN code displayed on the first line of the panel
display or press
then press the
The PIN code is printed.
9 Ensure that Start Configuration is highlighted, and then press the
(Set) button.
10 Ensure that the message Please wait Wireless Setting is
displayed, and enter the PIN code displayed on the step 7 into the wireless
LAN access point (Registrar).
NOTE:
manual supplied with the wireless LAN access point.
11 When the WPS operation is successful and the printer is rebooted, wireless
LAN connection setting is completed.
WPS-PBC
You can start Push Button Control only from the operator panel.
NOTE:
WPS-PBC (Wi-Fi Protected Setup-Push Button Configuration) is a
method to authenticate and register devices required for wireless configuration, by
pressing the button provided on the access point via wireless routers, and then
performing WPS-PBC setting on the operator panel. This setting is available only
when the access point supports WPS.
1 Press the
2 Press
button until System Setup is highlighted, and then press the
(Set) button.
3 Press
button until Admin Menu is highlighted, and then press the
(Set) button.
4 Press
button until Network is highlighted, and then press the
button.
76
Installing Optional Accessories
button until Print PIN Code is highlighted, and
(Set) button.
For WPS operation on the wireless LAN access point, refer to the
(Menu) button.
(Set) button.
(Set)
(Set)