Labconco Spectrum 177050100 User Manual page 47

Step 4
Take note of how the motor harness is connected prior to removal. Remove the wire
connectors to the motor and carefully set aside. The harness will be reconnected to the
replacement motor later.
Step 5 (For the 2 HP only)
The band heater must be removed from the motor being replaced. Using a flat head
screwdriver, loosen the band clamp enough to slide off the back of the motor. Unwrap
the heater carefully and pull away from the motor. Save the heater and the clamp.
Step 6
Remove the mounting hardware that supports the motor frame using a 7/16" rachet and
a 7/16" wrench and remove the ECM or VFD motor. Hardware is shown in Figure 8-1
and must be saved.
Step 7
Install the replacement motor by following Steps 1 through 6 in reverse order.
47