Infineon EVAL-PS-DP-MAIN-M5 Manual page 17

p u b l i c
EVAL-PS-DP-MAIN-M5
Evaluation platform for 600 – 1200 V SiC MOSFETs and IGBTs in TO-247
4pin/3pin packages
Table of contents
The start-up procedure includes the following steps:
Mount the drive card on the motherboard and set the jumpers to the required supply voltage.
1.
Plug the DUTs into the connectors on the daughter board connected to X100, X107, and X110.
Connect the power source (V
pulse). Setting current limits is recommended for safety reasons.
Connect the load inductor, either high-side or low-side HS or LS.
Plug in the desired probes (voltage, current).
To begin the turn-on procedure:
a. Apply 15 V and double pulse.
b. Gradually apply high voltage till the desired level is reached.
c. Proceed with measurements.
To begin the turn-off procedure:
a. Switch off the high-voltage source.
b. Switch off the auxiliary supply and function generator.
Additional guidance on double-pulse control using the controller card is available in [4].
User guide
up to 800 V), 15 V auxiliary supply, and function generator (for double
DC
17 Revision 1.0
2025-01-10