Printer Problems - Dell XPS 210 Owner's Manual

I F T H E P O W E R L I G H T I S O F F
• Reseat the power cable in the power connector on the back of the computer and the electrical outlet.
• Bypass power strips, power extension cables, and other power protection devices to verify that the
computer turns on properly.
• Ensure that any power strips being used are plugged into an electrical outlet and are turned on.
• Ensure that the electrical outlet is working by testing it with another device, such as a lamp.
• Ensure that the main power cable and front panel cable are securely connected to the system board (see
"System Board Components" on page 65).
I F T H E P O W E R L I G H T I S S T E A D Y A M B E R
• Ensure that the processor cable is securely connected to the system board (see "System Board
Components" on page 65).
• Remove and then reinstall all memory modules (see "Memory" on page 66).
• Remove and then reinstall any expansion cards, including graphics cards (see "Cards" on page 70).
F T H E P O W E R L I G H T I S B L I N K I N G A M B E R
I
internal power problem may exist.
• Ensure that the voltage selection switch is set to match the AC power at your location (if applicable).
• Ensure that all components and cables are properly installed and securely connected to the system
board (see "System Board Components" on page 65).
E L I M I N A T E I N T E R F E R E N C E
• Power, keyboard, and mouse extension cables
• Too many devices connected to the same power strip.
• Multiple power strips connected to the same electrical outlet

Printer Problems

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
NOTE:
If you need technical assistance for your printer, contact the printer's manufacturer.
C H E C K T H E P R I N T E R D O C U M E N T A T I O N
troubleshooting information.
E N S U R E T H A T T H E P R I N T E R I S T U R N E D O N
44
Solving Problems
— The computer is either turned off or is not receiving power.
— A device may be malfunctioning or incorrectly installed.
— The computer is receiving electrical power, but an
— Some possible causes of interference are:
— See the printer documentation for setup and