MULTISPAN MS-1208-M1 User Manual page 2

ENVIRONMENT CONDITION:
Operating Temp.
Relative Humidity
Protection Level
(AS Per Request)
Terminal Diagram
0 1 2 3 4 5 6
PT-100/3W PT-100/3W
- -
T/C CH-1 T/C CH-2
+ +
8 CHANNEL SCANNER
www.multispanindia.com
Range: 'J' : 0 To 600°C
PT-100/3W : -99 To 400°C
Output: RS-485(Modbus)
Made in India
~
100
(J,K, PT-100 with DP Selectable)
270V AC
!
50/60 Hz 50/60 HZ RS-485
3VA 4VA
MODBUS
A -
O/P
L N
26
0°C to 55°C
UP to 95% RH
(non-condensing)
IP-65 (Front side) As per IS/IEC
60529 : 2001
7 8 9 10 11 12 13
PT-100/3W PT-100/3W
- -
T/C CH-3 T/C CH-4
+ + +
'K' : 0 To 1200°C
- -
CH-8 CH-7
+ + +
T/C T/C
B+
PT-100/3W PT-100/3W
25 24 23 22 21 20 19
Key Operation
* Press
* Press
* Press
* Press
Procedure
1) Do all connection as shown in connection diagram.
2) To enter in parameter menu, press
14 15
Configure:
PT-100/3W
- 3. Scan time, 1 to 99
T/C CH-5
4. Sensor Selection ( J, K or PT-100 Selectable & DP
Selectable) (1-8) Channel
5. Skip or unskip channel (1-8) Channel
6) If needed to add offset, press
Set offset for each channel if required. (1-8) Channel
Off set range will be -99°C to + 99°C.
7) Press
-
scrolling.
CH-6
T/C
8) In hold mode use
PT-100/3W
18 17 16
Page 3
& key to change the parameter setting.
+ key for 5 sec to enter in Modbus menu.
SET
+ key for 5 sec to set OFFSET.
key to in scroll & hold mode.
ENT
Key for continuous scrolling or manual
ENT
& Key to select next channel.
key for 3 sec
SET
+ together for 5 Sec.
Page 4