Foreword Thanks for purchasing Comica EJoy D10 Pro Main Features · Innovative Wired/Wireless modes, Single and Dual Channels Options · Cardioid Polar Pattern, Anti-noise Large Diaphragm Dynamic Mic · XLR/USB-C Digital/Analog Outputs, Wide Compatibility · 48kHz/24bit Recording, Built-in Sound Card, One-key Calmix ® Denoise ·...
Page 4
Do not use the equipment in rain or in a damp environment to avoid short-circuit danger Please store the product in a dry environment EJoy D10 Pro has been granted type certification in accordance with the provisions of Article 38-24(1) of the Japan Radio Law 220-JP8047...
Page 7
Components and Instruction Microphone(TX) Dynamic Mic Capsule Microphone Sponge RGB Light Power/Denoise Button Status Indicator Light Monitoring Volume Knob/ Muting Button EQ E ect Indicator Light Gain Adjustment Switch EQ E ect Button RGB Light Button 3.5mm Headphone USB-C Port Monitoring Port XLR Port Receiver Storage...
Page 8
1. Dynamic Mic Capsule 2. Microphone Sponge 3. RGB Light Audio dynamic/comica orange/ sea wave/colorful breathing light/RGB slow wave/rotating rainbow six RGB light e ects; Red light keeps on during muting status 4. Power/Denoise Button Long press to turn the power on/o ; short press to turn denoise on/o 5.
Page 9
9. EQ E ect Indicator Light Bass Orange Nature Blue Bright Green Pairing Blue light blinks quickly 10. RGB Light Button Long press to turn light e ect on/o ; short press to switch six light e ects Long press the EQ E ect Button and RGB Light Button to enter pairing status 11.
Page 10
Receiver (RX): USB-C Port USB-C Port:Connect to USB devices for digital audio output The receiver can be stored on the groove of the microphone stand...
Page 11
Installation and Usage Boom Arm Kit Installation: 1.Clamp the stand base of boom arm to the desktop, tighten the screw on the bottom clockwise 2. Insert the boom arm into the base socket, fix and adjust it by the screws on the side of the base...
Page 12
3. Connect the mic threaded hole to the boom arm's screw, rotate clockwise to fasten 4. Adjust and fix the mic through the locking knob on boom arm...
Page 13
Desktop Stand Kit Installation: 1. Connect the threaded hole of mic to the screw of the desktop mic stand, rotate clockwise to fasten 2. Adjust the angle of mic through the locking knob on it...
Page 14
Usage: Wired Mode 1.Digital Output Connect the mic to smartphone/computer through audio output cable, choose whether to monitor according to your needs Adapter Adapter Cable 1. Please purchase a USB C-Lightning adapter/cable that supports OTG function when connected to lightning port devices 2.
2.Analog Output Connect the mic to audio interface/recorder/mixer via the XLR-XLR or XLR-3.5mm TRS audio cable 1. When outputting analog audio through the XLR port in wired mode, all other functions are unavailable except for the dynamic audio signal delivery (Such as status indicator light, EQ e ect, gain adjustment, RGB light e ect, real-time monitoring, etc.) 2.
Wireless Mode Pairing(The mic and receiver are paired by default. If you need to re-pair in special circumstances, please refer to the following pairing method) 1.Turn the microphone(TX) on, then long press the EQ E ect Button and RGB light Button in sync 2.Connect the receiver(RX) to a device to make it enters wireless status.
Page 17
Usage When connect receiver to a device, please refer to the following connection methods: Adapter Adapter Cable Please purchase a USB C-Lightning adapter/cable that supports OTG function when connected with lightning port devices...
Need help?
Do you have a question about the EJoy D10 PRO and is the answer not in the manual?
Questions and answers