bouncepad VESA Assembly Instructions

VESA
Assembly Instructions
Tools Required:
Pencil
Electric Drill
2.5mm Drillbit
*if fixing to a surface
Socket Driver
16mm *if routing the tablet
cable through your
Holesaw
mounting surface
Sheet Code: BP-IM-036_REV3
Release Date: 03/09/2024
Copyright 2024 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Confidential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
Follow steps A if "Fixing
A
to a surface".
A3
Feed the Cable through the VESA with your chosen cable management setup.
Faceplate Case
VESA Mount
Tablet Set-up Kit
Fixings Kit
Pair of Keys
In the Box
Follow steps B if "Fixing
B
to a VESA Mount".
1x T20 Pin
Torx Driver Bit
1x Case
Washer
4x No.8
Buttonhead
Self tapping
Screw
4x M4x20mm
Buttonhead
screw
4x M4 Split
Washer
Fixings List
* Due to the modular nature of our product range
you may receive additional fixings in the fixings kit
Position & mark were the
A1
VESA is to be located.
Ensure the VESA is level.
T20 Pin Torx
Driver Bit
A4
Paper Clip
Remove the VESA Fixing
1
Covers with a Paper Clip.
Drill central
16mm hole
if running
cable through
surface.
Drill the fixing holes into
A2
your surface.
4x No.8 Buttonhead
Self tapping Screw
*fixings not provided.
Secure the Bouncepad VESA to the
mounting surface.