bouncepad Floorstanding Slim Assembly Instructions

Floorstanding Slim
Assembly Instructions
Tools Required:
Pencil
Socket Driver
Drill
*or adjustable spanner
Drillbit
*Please note that the drillbit size & type will be
determined by your chosen fixing method and
material of the mounting surface.
Ensure you have access to the appropriate tools
to secure the Floorstanding to your mounting
surface.
*Bouncepad does not provide these fixings.
Sheet Code: BP-IM-048_REV2
Release Date: 28/10/2019
Copyright 2016 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Confidential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
Front
Position & orientate the
1
Floorstanding pole in the
location of final install.
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
T20 Pin Torx Driver Bit
M4x20mm Button head screw
Case Washer
Locate and secure the Case onto the
5
Mounting Arm as shown. Tighten by
hand.
Tablet Set-up Kit
Fixings Kit
In the Box
Mark the drill hole
2
locations on the
mounting surface.
M4 Split Washer
6
Unlock & remove the Faceplate from
the Bouncepad Case.
Faceplate
Case
Pair of Keys
Floorstanding
Rubber Collar
Floorstanding
Slim Cover
*Drill bit type & size is determined
by your chosen fixing method.
*Fixings to secure the Floorstanding
Pole are not provided.
Drill all four fixing holes
3
into the mounting
surface.
Floorstanding
Pole
1x T20 Pin
Torx Driver Bit
1x Case
Washer
Fixings List
* Due to the modular nature of our product range
you may receive additional fixings in the fixings kit
Locate the Floostanding
4
Slim Cover over the
Floorstanding Pole.
Feed the tablet power cable
7
through the Bouncepad Case and
Floorstanding Pole.
4x M4 Split
Washer
4x M4x20mm
Buttonhead
screw