bouncepad Wallmount Assembly Instructions

Wallmount
Assembly Instructions
Tools Required:
Pencil
Electric Drill
7mm Spanner
*or adjustable spanner
5.0mm Drillbit
*if fixing from below
2.5mm Drillbit
*if fixing from above
16mm *if routing the tablet
cable through your
Holesaw
mounting surface
Socket Driver
Sheet Code: BP-IM-033_REV2
Release Date: 24/10/2019
Copyright 2016 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Confidential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
Minimum Mounting
surface thickness :
Metric Imperial
34 1
mm 5/16"
Follow steps B if "Fixing
B
from Above".
Mount Washer 7mm Spanner
M4 Split washer
M4 Locking Nut
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
Mount Washer
M4 Split washer
M4 Wing Nut
Secure the arm to the
A4
surface. Locking Nuts
offer higher security.
Tablet Set-up Kit
Fixings Kit
Faceplate
Case
Pair of Keys
Wallmount
Arm
Surface
Mounting Kit
In the Box In the Box
Mount Washer
Top
4x Ø5.0mm
1x Ø16.0mm
Using the Mount washer,
A1
mark the drill hole
locations as shown.
*see overleaf
A5 B1
Go to step 1.
4x No.8
4x M4x10mm
Countersunk,
Countersunk
Self tapping Wing Nut
Screw
Screw
4x M4x40mm 4x M4x20mm
Socketset Buttonhead
screw screw
1x T20 Pin
Torx Driver Bit
1x Mount 1x Case 8x M4 Split
Washer Washer Washer
Fixings List
* Due to the modular nature of our product range
you may receive additional fixings in the fixings kit
Ø5.0mm Drillbit
*Bouncepad accepts zero responsibility for damage
caused due to incorrect assembly methods.
Ø16.0mm Holesaw
Drill each hole - using the
A2
specified drill size.
Mount Plate
Top
1x Ø16.0mm
4x Ø2.5mm
Using the Mount Plate,
B2
mark the drill hole
locations as shown.
4x M4
4x M4
Locking
Maximum Mounting
Nut surface thickness :
Metric Imperial
25 1"
mm
Follow steps A if "Fixing
A
from below".
M4x40mm
Socketset
screw
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
Top
Locate and screw the Socket screw
A3
into the Wallmount as shown.
Ø2.5mm Drillbit
Ø16.0mm Holesaw
Drill each hole - using the specified
drill sizes.