bouncepad Original Floorstanding + Brother Printer Mount Assembly Instructions

Original Floorstanding +
Brother Printer Mount
Assembly Instructions
Tools Required:
Socket Driver
10mm Spanner
*or adjustable spanner
Sheet Code: BP-IM-057_REV3
Release Date: 14/05/2025
Copyright 2025 SpotSpot Ltd. (T/A
Bouncepad) all rights reserved.
Confidential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
Brother Printer Mount
Due to the modular nature of our
product range you may receive
additional fixings in the fixings kit.
In the Box
(Printer Mount)
T20 Pin Torx Driver Bit
Neck-Ring
4x
M4x16mm
Buttonhead
Screw
Remove Neck-Ring
3
using T20 driver bit &
Socket Driver.
Base
In the Box
(Floorstanding)
Tighten screw(s) using hand
tools, using electric tools may
damage your Bouncepad.
4x M3x10mm
Buttonhead
Screw
1x T10 Pin Torx
Allen Key
Orientate, locate & secure the Floorstanding Pole
Fixings List 1
to the Base as shown. Ensure that all fixings are
(Printer Mount)
installed correctly.
Feed the Printer's Power Cable through the Floorstanding
4
Pole.
Faceplate
Pair of Keys
Case
Tablet Set-up Kit
Fixings Kit Rubber Collar
Cover
4x M6 Nylon
Locking Nut
4x M6
Split
Washer
4x M6x25mm
Countersunk
Screw
PZ3 Pozi
Driver Bit
Floorstanding
Pole
1x Case
Washer
4x M4x16mm
Buttonhead
Screw *
4x M6 Split
Washer
4x M6
Locking Nut
Fixings List
Due to the modular nature of our product range
you may receive additional fixings in the fixings kit.
* Previous models may have been supplied with
20mm.
10mm
Spanner
Locate the Cover over the
2
Floorstanding Pole.
T10 Pin Torx
Allen Key
4x M3x10mm
Buttonhead
Screw
*Designed for Brother QL-820NWB
*Printer is not provided.
Attach the Printer to the Printer
5
Mount using M3x10mm Screws
4x M4 Split
Washer
1x T20 Pin
Torx Driver Bit
4x M6x25mm
Countersunk
Screw
1x PZ3 Pozi
Driver Bit
(Floorstanding)