bouncepad Lounge Assembly Instructions

Lounge
Assembly Instructions
Tools Required:
Socket Driver
Sheet Code: BP-IM-044_REV2
Release Date: 28/10/2019
Copyright 2016 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Confidential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
Ensure the Lounge Cone is orientated
2
correctly as shown, with the cable
exiting the Cone at top.
Unlock & remove the
5
Faceplate from the
Bouncepad Case.
Tablet Set-up Kit
Fixings Kit
Faceplate
Case
Lounge Mounting
Arm & reinforced
cable
Pair of Keys
In the Box
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
3
Secure the Lounge Cone to the Case.
4x Tablet Supports
4x Corner Pieces
1x Cable Clip
Install the Tablet Setup Kit. Each
6
kit is specific per tablet device and
Bouncepad Case.
1x T20 Pin
Torx Driver Bit
4x M4 Split
Washer
4x M4x20mm
1x Case
Buttonhead
Washer
screw
* Due to the modular nature of
our product range you may receive
additional fixings in the fixings kit
1
Fixings List
T20 Pin Torx
Driver Bit
M4x20mm
Buttonhead
screw
M4 Split Washer
Case Washer
4
Install the tablet into the Case, connecting
7
the power cable to the tablet.
Feed the Bouncepad Lounge
reinforced cable through the Case as
shown.
M4x20mm
Buttonhead
screw
M4 Split Washer
With the remaining fixings, secure
the reinforced cable to the Case.