Alienware AW2725QF User Manual page 44

OSD warning messages
When the monitor does not support a particular resolution, you can see the following message:
This means that the monitor cannot synchronize with the signal that it is receiving from the computer. See
the horizontal and vertical frequency ranges addressable by this monitor. Recommended mode is 3840 x 2160.
NOTE: The message that appears on the monitor varies based on the type of input cable used.
You can see the following message before the DDC/CI function is disabled:
When the monitor enters the Standby Mode, the following message will appear:
Activate the computer and wake up the monitor to gain access to the OSD.
When you increase the Brightness level above the factory default setting for the first time, the following message appears:
When you select FPS/MOBA(RTS)/SPORT under Preset Modes in the Game menu OSD for the first time after factory reset, the
following message appears:
Operating the monitor
44
Alienware 27 Monitor
The current input timing is not supported by the monitor display. Please
change your input timing to 3840x2160, 60Hz
listed timing as per the monitor specifications.
Figure 37. Resolution warning message
Alienware 27 Monitor
The function of adjusting display setting using PC application will be
disabled.
Do you wish to disable DDC/CI function?
Yes
Figure 38. DDC/CI warning message
Alienware 27 Monitor
Going into Standby mode...
Figure 39. Standby mode warning message
Alienware 27 Monitor
Adjusting to this value will increase power consumption above the
default level. Do you want to continue?
Yes
Figure 40. Power warning message
or any other monitor
AW2725QF
No
AW2725QF
AW2725QF
No
AW2725QF
Monitor Specifications for