Removing/Replacing the Hard Disk Drive Module
The procedure for removing and replacing the hard disk drive module is as follows:
1.
Turn off the computer. Close the LCD cover and turn the whole unit over.
You will find a clamp latch (lock knob) that secures the hard disk drive module to
2.
the system unit. To remove the hard disk drive module, push the lock knob side-
ways with one hand and with the other hand pull the hard disk drive module out.
Note that this has to be done simultaneously.
To replace the hard disk drive, remove the four flat screws attaching it to the null
3.
hard disk assembly and remove the hard disk drive cable.
4.
To replace the hard disk drive module, reverse the above procedure.
Removing/Replacing the Diskette Drive Module
The procedure for removing and replacing the diskette drive is as follows:
Turn off the computer. Close the LCD cover and turn the whole unit over.
1.
2.
You will find a clamp latch (lock knob) that secures the diskette drive module to
the system unit. To remove the diskette drive module, push the lock knob side-
ways with one hand and with the other hand pull the diskette drive module out.
Note that this has to be done simultaneously.
Figure 4-1 Hard Drive Module Assembly
Field Service Guidelines
4-5