Removing/Replacing The Lcd Status Bar Cover And Hinges - NEC Versa 2500 Series Service Manual

4-6 Field Service Guidelines
3. To replace the diskette drive, remove the four flat screws attaching it to the null
diskette assembly , two attaching the diskette cover and remove the diskette drive
cable.
4. To replace the diskette drive unit, remove the four small screws attaching it to the
null diskette drive assembly and remove the diskette drive cable.
To replace the diskette drive module, reverse the above procedure.
5.

Removing/Replacing the LCD Status Bar Cover and Hinges

Remove the LCD Status Bar Cover and Hinge Covers are as follows:
Turn off the computer. Follow all disassembly procedures mentioned from the
1.
start of this section.
Slide the left and right hinge covers out to remove them.
2.
3. Lift the status bar cover out.
4. To replace the LCD Status Cover and Hinge Covers, reverse the removal proce-
dures mentioned above.
Figure 4-2 Diskette Drive Module Assembly