hergom C-10-SE Installation, Use And Maintenance Instructions page 14

7. CLEANING
7.1. FROM THE CAST IRON FRONT.
Cleaning should preferably be done when the insert
is cold, using slightly damp cloths.
7.2. OF THE DOOR GLASS
Stove glass cleaners are quite effective products.
Never try to clean the glass while the stove is
operating.
Substitution. The glass of its insert is thermal,
manufactured especially for wood and/or charcoal
stoves. In case of accidental breakage, it must be
replaced with another one with the same
characteristics. Contact our Distributor to supply
you with the appropriate glass, accompanied by
assembly instructions and gaskets.
8. SECURITY
Warning
Gas/wood/pellet appliances become hot during operation.
Consequently, you must act with caution and stay away, especially avoid the proximity of children, the elderly
or other people who require special attention, as well as pets while the device is on.
Make sure that children or other people unfamiliar with the operation of the appliance are supervised by
responsible persons when they approach it.
To protect against burns and to protect the approach of children or people who should not come into
contact with the appliance, place a firebreak or separator. We recommend the use of fireproof gloves when
handling the appliance.
Fig. 1
7.3. OF THE DEFLECTOR PLATE
1. Slide the deflector plate forward and upward
until the pivots are removed from the sides of the
deflector housings (Fig.1).
2. Move the deflector downwards, leaving the
piece free (Fig.2).
3. Clean the deflector plate on both sides every
season.
4. Reassemble the deflector plate following the
steps described in point 1 in reverse order.
7.4. JOINTS AND SEALINGS
It is recommended at the beginning and middle of
the season to visually check the condition of the
joints (doors, glass, etc.) and sealing of parts, in
case it is necessary to replace or repair them.
Fig. 2