hergom C-10-SE Installation, Use And Maintenance Instructions page 13

6. IGNITION AND COMBUSTION REGULATION
To regulate combustion you must follow these recommendations:
BY MOVING
-
the lever to the left, the air supply for
combustion is closed CLOSE (see figure).
TO PROMOTE IGNITION,
-
It is recommended to move the combustion
regulation knob completely to the right. OPEN
It is essential to carry out an abundant charge at
ignition. The following loads will depend on the
desired heat need.
It is advisable to leave the insert door partially
open to prevent condensation from forming
and staining the glass during the first minutes
of ignition.
Once the insert is operating at a normal regime
and the chimney has been perfectly heated, we
will regulate the combustion using the
regulation knob, in this way, by completely
closing the air inlet, the combustion will
become slower and will be quickened when
Let's open the air inlet.
To obtain maximum performance from the
appliance, the combustion regulation handle
must be left in its middle position.
When in the same room the compact is going to
operate simultaneously with other heating
devices that require air for combustion, it is
recommended that an additional inlet of
outside air be provided to facilitate their
combustion.
The operation of one or more heating devices
in the same room causes the oxygen level to be
reduced, making combustion in the home
difficult and the chimney draft is reduced..
CAREFUL! During the operation of the home,
metal parts can reach high temperatures. It is
necessary to protect your hands with a
fireproof mitt if you need to handle it.
In case you detect overheating in the home
caused by:
- Fan failure.
- Thermostat breakage.
It is necessary to stop the appliance to avoid
breakage of the cast iron parts. To do this, the
following recommendations must be followed:
-Do not charge the device anymore
-Open the door slightly allowing more air to
enter, this will fan the flame, consuming it
faster, but at the same time it will cool the
chimney and reduce the draft, cooling the
device.
Your Insertable is not designed to work with
the intermittent combustion system